LG LW1014CR Guide D'utilisation page 13

4. Put the Support Bracket against the outside
wall and tighten the Bolts on top of the
Bracket. Adjust the Leveling Bolt so that the
air conditioner will be installed with a v ery
slight tilt (about 1/4") downward toward the
outside for proper drainage.
Tighten the nut. (Fig. 3)
DO NOT drill a hole in the bottom of
NOTICE
the base pan. The air conditioner is
designed to operate with the bottom
of the base pan approximately half-full
of water.
5. Fasten Side Guides to the sides of the Air
Conditioner using 3 Type A screws per Guide.
Start with first screw at middle of Guide.
(Fig. 4)
6. Fasten Upper Guide on the top of the Air
Conditioner using 3 Type A screws. (Fig. 4)
7. Measure height of window opening from top
of Bracket assembly as shown Fig. 5.
Subtract 20 3/4". Mark this
measurement on Curtain and cut the Cur tain.
(Fig. 5)
8. Slide Curtain into Curtain Frame. Slide
Curtain Frame assembly into side Guides of
the Air Conditioner cabinet. Make sure
Curtain is firmly enclosed on all sides b y the
Frame. (Fig. 6)
Fastening Side Guides
Upper Guide
C
Curtain
Installation
Fig. 3
Side Guide
Fig. 4
Fig. 5
Frame Curtain
Fig. 6
Owner's Manual 13