Greencut GM650X Manuel D'utilisation page 71

MULTITHREADED REEL INSTALLATION
1. Place the inner support on the gearbox shaft and turn it to fix it with the supplied L-
shaped wrench.
2. Place the reel in the inner support in the gearbox so that the hole in the multi-threaded
disc corresponds to the hole in the inner support.
3. Place the outer support on the gearbox shaft with the hole facing the reel.
4. Place the bolt cover on the outer support and tighten with the bolt (left screw) together
with the spring washer and washer.
AUTOMATIC REEL INSTALLATION
1. Correctly place the inner and outer bracket on the gearbox shaft.
2. Screw the supplied bolt (M8 left) onto the gearbox shaft and tighten it with the spanner.
3. Screw the nylon thread onto the bolt by fixing the inner support with the L-shaped rod and
adjusting it manually.
MOUNTING AND ADJUSTING THE MOWER
ATTENTION: The cutting blades are very sharp. Do not handle the cutter assembly unless the
protective cover of the blade is in place.
ATTENTION: Make sure that the "cutter bar" is locked in the storage/transport position (folded
back) and the protective cover is installed over the cutting blades when not in use.
1. Grasp the handle behind the hand guard with your right hand, and with your left hand, grasp the adjustment
lever of the blade assembly.
2. With the index finger of your left hand, press the release latch. With your left thumb, press the locking latch.
3. The cutting blade can be adjusted in various positions.
4. Remove the cover from the cutting blade. Now you can start the engine.
71
EN