Greencut GM650X Manuel D'utilisation page 70

70
MOUNTING THE BARS
Steps to follow:
1. Release the clamping handle (2) until the accessory bar
snaps in gently.
2. Pull out the safety pin (1) and push the bar into the joint
until it reaches the maximum depth. Make sure the drive
rod fits properly into the power take-off shaft drive.
3. Turn the accessory bar until the safety pin snaps into the
accessory bar housing.
4. Tighten the lever (2) until you have checked that the
accessory bar is securely fastened.
MOUNTING THE SAFETY GUARD
1. Remove the two bolts and the baffle plate with an Allen wrench and set aside.
2. Place the deflector guard over the gear head.
3. Secure the guard in place with the two bolts you previously put aside, using the Allen wrench.
4. Place the blade in the blade guard and secure it with the two screws.
INSTALLING THE METAL DISC
1. Place the inner support on the gearbox shaft and turn it to fix it with the supplied L-shaped
wrench.
2. Place the disc in the inner bearing bracket in the gearbox so that the blade hole corresponds
to the fit of the inner bearing bracket.
3. Place the outer support on the gearbox shaft with the hole facing the blade.
4. Place the bolt cover on the outer support and tighten with the bolt (left screw) together with
the spring washer and washer.
2
1