VINCENT SP-331MK Manuel D'utilisation page 22

4. SPEAKERS: Loudspeaker terminals
At these output sockets with threaded terminals
one or two pairs of loudspeakers can be connec-
ted. Speaker cable with 4 mm banana plugs can
be used. Please take note of the information given
in the section "Installation", if two pairs of loud-
speakers will be connected to the amplifier.
5. INPUT: Input for preamplified
mono audio signal
This input must be connected with the output con-
nectors of the preamplifier for the desired chan-
nels. For example, with "PRE OUT R"/ "PRE OUT
L", if the SP-331MK is to be used for the loudspea-
kers of a stereo system. Do not connect any line
level sources!
Vincent
22
REAR VIEW
4
5
6. FUSE: Fuse holder
This small plastic housing holds the fuse. Refer to
the security precautions.
7. AC 220-240V: Power Connector
To establish the power supply, connect the plugs
of the power cable to the device and to a suitab-
le wall outlet.
6 7