Electrical Connection - ADEO SCREEN Screen Research MMS2-4-IS Manuel D'installation Et D'utilisation

Rolling screen installation and operation manual
The type of motor installed on the product is identified by a label applied on each product showing the CE logo. When unwrapping the product please check the model type indicated on the label in order to
perform the installation and cable connections correctly. Should the power of the motor be different from that of the supply network of the installation place, please contact an electrician to have a current and
Hz transformer installed.
Technical characteristics - Fabric:
Nice ERA INN EDGE –AC
100-240V 50-60Hz:
Frequency: ~Hz50-60
Power: 70W
Torque: 10Nm
Speed: 20Rpm
Duty cycle: S2 4min
Cable length: 1.5mt
Mechanical strength: EN14202 conformant
Operating T°:
from –20 to +55 °C
Frequency: 433.92 MHz
Trans. range: 150mt
Weighted sound pressure level:
LpA ≤ 70 dB(A)
Motor protection class: IP44
Technical characteristics - Mask:
Nice ERA INN EDGE –AC
100-240V 50-60Hz:
Frequency: ~Hz50-60
Power: 70W
Torque: 6Nm
Speed: 32Rpm
Duty cycle: S2 4min
Cable length: 1.5mt
Mechanical strength: EN14202 conformant
Operating T°:
from –20 to +55 °C
Frequency: 433.92 MHz
Trans. range: 150mt
Weighted sound pressure level:
LpA ≤ 70 dB(A)
Motor protection class: IP44
Made by Adeo Screen Sp. Z o.o. (Poland) Specifications are subject to change without notice. E&OE
Please verify that you are working with the latest revision of this document before specifying your screen.
Doc: MMS2-4-IS Installation Manual rev1 | 24.10.2018
09 MOTOR TYPE IDENTIFICATION –CHARACTERISTICS – ELECTRICAL CONNECTION
ELECTRICAL CONNECTION: electric cabling must be conformant with applicable IEC standards. IEC norm EN 60335-1 requires that supply network be
fitted with an omnipolar selector switch with contact opening distance of at least 3 mm.
For each motor (e.g. plug switch etc.). In case of need, this device ensures that the power supply is safely and quickly cut off.
Use the wires as described in the figure.
ATTENTION:
This product contains two motors, which must both be wired in the same manner.
Bus cables must be insulated if not used for the push-button command.
WARNING: Correctly performed, state-of-the-art, norm-compliant electrical connections are important to prevent accidents and to ensure the screen's
optimal and unaltered performance over time. Prior to carrying out any operation on electrical parts ensure that power supply is disconnected.
Bus cables (black white orange) must be insulated if not used for the push-button command.
In screens fitted with cases the motor is positioned on the right-hand side of the screen as seen from the front.
Operates with standard radio control (supplied).
ENGLISH
Connection for each motor:
A1 –
White (power supply phase)
A2 –
Black (neutral)
A3 –
Yellow-green (earth)
B1 –
White-orange (up command)
B2 –
White (down command
TTBus)
B3 –
White-black (common)
Connection for each motor:
A1 –
White (power supply phase)
A2 –
Black (neutral)
A3 –
Yellow-green (earth)
B1 –
White-orange (up command)
B2 –
White (down command
TTBus)
B3 –
White-black (common)
Page 13