ADEO SCREEN Screen Research MMS2-4-IS Manuel D'installation Et D'utilisation page 16

Rolling screen installation and operation manual
Each programming procedure consists of several steps; at the end of each step, the operator has 60 seconds to start the next step; this system is devised to prevent the risk of performing operations other
than those desired. Therefore, if the motor does not perform the operation exactly as indicated in the instructions, wait 60 seconds, then exit programming, or cancel the procedure as indicated at specific
point, and start the procedure all over again.
ENGINE 1 – 2 – 3
The motor's settings follow an overwriting logic: therefore, once the end stop positions have been memorised they cannot be cancelled, but only overwritten by following the above-mentioned procedure from
the start.
In order to cancel the procedure in course, simultaneously press ■ and ▼ at any time, until the motor has executed 6 movements.
Made by Adeo Screen Sp. Z o.o. (Poland) Specifications are subject to change without notice. E&OE
Please verify that you are working with the latest revision of this document before specifying your screen.
Doc: MMS2-4-IS Installation Manual rev1 | 24.10.2018
Before start the programmation choose the engine you want to program with the number button, 1 – fabric motor, 2 – masking motor
Top, 3 – masking motor Lateral.
Do the sequency below for each engine.
ENGINE 1 – 2 – 3
With the Master remote control and the
▲▼ ■ keys, bring both screens
approximately to the position that you
intend to programme (to check the exact
size of the format required, we recommend
that you project some images of the
relevant format), then proceed as follows
Press and release the button PRG, the
engine performs 2 movements.
Keep ▲ and ▼ keys simultaneously
pressed until the motor performs 2
movements
Note: at this stage, in order to perform
precision adjustments both the motors
must be moved exclusively with the ▲▼
keys. The remote control will operate in a
stuttering mode. In order to perform
millimetric adjustments press the ▲ or ▼
key briefly. To perform longer movements
(but still in a stuttering mode) keep the ▲
or ▼ key pressed. Proceed in this manner
to position the two canvases exactly where
you want to programme them.
Once the required position is reached,
keep the ■ key pressed until the motor has
finished performing 3 movements.
Press a button (from 1 to 5) the button of
the PILOT remote control which you intend
to associate to the format, until each
motor has finished performing 4
movements.
The required format is now
memorized on the Pilot remote
control of your choice (1-5) and the
programming procedure is
concluded.
TO CANCEL THE PROGRAMMING IN COURSE
RATIO MEMORIZATION
ENGINE 1
MOVEMENT OF FORMAT
ENGLISH
ENGINE 2 ENGINE 3
Page 16