EINHELL FREELEXO Instructions D'origine page 44

The alarm LED (53) is lit up red
Fault
"Hall-eff ect sensor"
The robot lawn mo-
wer has come to a
stop right next to an
obstacle.
The alarm LED (53) fl ashes red
Fault
"Perimeter wire/sig-
nal fault"
The robot lawn mo-
wer goes round in
circles to search for
the perimeter signal
and ultimately co-
mes to a complete
stop.
The alarm LED (53) fl ashes blue
Fault
"Rechargeable bat-
tery/battery fault"
The rechargeable
battery does not
charge up.
Anl_FREELEXO_SPK9.indb 44 Anl_FREELEXO_SPK9.indb 44
GB
Possible cause
- The obstacle sensor has
been continually tripped for
10 seconds
Possible cause
- The robot lawn mower is out-
side the mowing area
- Perimeter wire (18) is not
properly connected
- Perimeter wire (18) is se-
vered
- No power supply
Possible cause
- Poor charging pin (20) con-
tact
- The rechargeable battery
(22) has reached the end of
its service life
- 44 -
Remedy
Switch off the main switch (7) (OFF) and
place the robot lawn mower at a diff erent
point in the mowing area. Switch on the main
switch (7) again (ON) to restart the robot
lawn mower.
- Check whether the robot lawn mower
is blocked by an obstacle or jammed
between trees, bushes, etc. Remove the
obstacle or avoid this area.
- If this fault occurs frequently, check the
way in which the perimeter wire (18) has
been laid. Pay particular attention to tight
angles, corridors, fences, rocks, etc., and
adjust the layout of the perimeter wire (18)
if necessary.
Remedy
Switch off the main switch (7) (OFF) and
then switch it back on (ON) again to re-
start the robot lawn mower.
- Check that the robot lawn mower is inside
the mowing area.
- Check whether the LED indicator (21) on
the charging station (19) is lit up green.
- If the robot lawn mower repeatedly leaves
the mowing area at the same point, check
the area for high voltage cables. Change
the position of the perimeter wire (18).
- If the robot lawn mower leaves the mo-
wing area on a slope, avoid the area by
changing the position of the perimeter
wire (18).
Remedy
Switch off the main switch (7) (OFF) and
then switch it back on (ON) again to re-
start the robot lawn mower.
- Please check if there is a problem with the
power supply.
- Clean the charging pins (20).
- Replace the rechargeable battery (22) if
necessary.
- Contact your customer service center.
14.11.2019 12:13:09 14.11.2019 12:13:09