PROMAT 4000873341 Mode D'emploi Original page 10

 The products included in this delivery may not be altered or modified.
 The product may only be connected to a power mains socket (230V~/50Hz)
which is according to regulations.
 Treat the product with care. Avoid mechanical shock,, impact or dropping it
from any height. The product may be damaged.
 Do not disassemble the unit or attempt to modify or repair it yourself. It does
not contain parts serviceable by you. In case of questions or problems, turn
to our customer service.
Intended Use
 The LED spotlight is intended for illuminating house entrances, driveways, etc.
It may be installed in outdoor areas and can be exposed to rain (IP 65).
 No part of the product may be modified or converted!
 The safety instructions must be observed at all times!
Preparations for Installation
 Observe the safety instructions!
 Without fail, pay attention to the correct mounting position of the LED spotlight
and the connection cable. If installed outdoors, make sure no water can enter
the housing or the socket when installing the connection cable.
 Only install the LED spotlight on a stable surface. Use screws and plugs that
are suitable for the surface.
 If the LED spotlight is mounted outdoors an earth leakage circuit breaker must
be installed (FI protective switch).
Mounting/Installation
 Install the wall mount with two or three suitable screws securely to an
appropriate place.
 Tilt the spotlight to the desired angle and tighten the screws at the hinge of the
wall mount to secure its position.
 Connect the power Plug of the LED spotlight to a suitable wall socket.
6
Operation