Blade Replacement - Cembre HT-TC051 Notice D'utilisation Et Entretien

ENGLISH

5. BLADE REPLACEMENT

After extended use, the blades may loose their cutting edge.
Replace the blades as follows:
5.1) Lower blade
– Release latch (28), open the head.
– Operate moveable handle to advance the lower blade (18) until holding screw (29) is visible on
the ram (14).
– Using a fl at blade, screwdriver remove the holding screw (29) and release the lower blade (18).
– Insert the new blade and fi t the holding screw.
Warning: before closing the head release the oil pressure and retract the lower blade (18), otherwise
the tool head assembly may hit and damage the lower blade.
5.2) Upper blade
– Release latch (28), open the head .
– Remove the circlip (20) and extract the head pin (19), enough to release the tool head assembly.
– Remove circlip (25) and pin (26), to release the latch (28). Remove latch spring from the upper
blade.
– Unscrew the 4 screws (21), remove the left hand guide (22), the right hand guide (24) and release
the blade (23).
– Fit the left and right hand guides to the new blade. Place the spring into its seat and refi t the
latch.
– Fit the blade assembly to the head (13), fully insert the pin (19) and secure with the circlip (20).
6. RETURN TO Cembre FOR OVERHAUL
In the case of a breakdown contact our Area Agent who will advise you on the problem and give
you the necessary instructions on how to dispatch the tool to our nearest service Centre; if possible,
attach a copy of the Test Certifi cate supplied by Cembre together with the tool or fi ll in and attach
the form available in the "ASSISTANCE" section of the Cembre website.
(Ref. to Fig. 3)
6