Table des Matières
Publicité
• All modifications of the device are forbidden for safety reasons.
Damage caused by user modifications to the device is not covered
• Only use the device for its intended purpose. Using the device in
by the warranty.
• Damage caused by disregard of certain guidelines in this manual
an unauthorised way will void the warranty.
is not covered by the warranty and the dealer will not accept
responsibility for any ensuing defects or problems.
4.
Installation
4.1
Installation Guidelines
• Avoid pointing the detector towards objects with highly reflective
• Avoid pointing the detector near heat sources such as heating
surfaces such as mirrors.
• Avoid pointing the detector towards objects that may move in the
vents, air conditioning units, etc.
• Install the detector at a distance of minimum 60 cm when using a
wind such as curtains, plants, etc.
lamp of 60 W or more.
4.2
Installation
1.
Remove the cover from the detector.
2.
Fix the bottom on the selected position with the appropriate
screws.
4.3
Connection
Risk of electroshock! Touching live wires can cause life-
• Have the device repaired by qualified personnel.
threatening electroshocks.
• Disconnect the power source.
• Cover and shield any adjacent live components.
• Ensure the device cannot be switched on.
• Make sure the power supply is disconnected.
1.
Connect the necessary cables according to the wiring scheme
inside the detector's housing. Make sure all connections are
tightly secured.
2.
Close the detector and switch on the power. Proceed with the test.
V. 02 – 16/11/2016
PIR050
4
©Velleman nv
Publicité
Table des Matières
