Technical Data - Char-Broil 16102040 Mode D'emploi

Leak Testing Valves, Hose and Regulator
Leak test before first use, at least once a year, and every time
the cylinder is changed or disconnected.
1. Turn all appliance control knobs to
2. Be sure regulator is tightly connected to gas cylinder.
3. Turn on Gas. If you hear a rushing sound, turn gas off
immediately. There is a major leak at the connection.
Correct before proceeding.
4. Brush soapy solution (mixture of half soap and half water)
onto hose connections.
5. If growing bubbles appear, there is a leak. Turn off gas at
cylinder immediately and check tightness of connections. If
leak cannot be stopped do not try to repair. Call for
replacement parts.
6. Always turn off gas at cylinder after performing leak test.

TECHNICAL DATA

Appliance Name Smoker, Roaster and Grill
Nominal Heat Input 5,3 kW (386 g/h)
Gas Category
Model No.
Gas Type
Gas Pressure
Injector Size Main Burner: 1,10mm
Hotplate: N/A
Destination Countries BE, CZ, FR, GB, IT, SK
.
I3+(28-30/37)
Butane Propane
28-30 mbar 37 mbar
SPIDER AND WEBS
INSIDE BURNER
If your barbeque is getting hard to light or the flame is
weak, check and clean the venturis and burners.
Spiders or small insects are known to create "flashback"
problems by building nests and laying eggs in the
barbeque's venturi or burner obstructing the flow of gas.
The backed-up gas can ignite behind the control panel.
This flashback can damage your barbeque and cause
injury. To prevent flashbacks and ensure good
performance, the burner and venturi tube assembly should
be removed and cleaned whenever the barbeque has been
idle for an extended period of time.
IF APPLIANCE FAILS TO LIGHT
Make sure gas is turned on at cylinder.
Make sure there is gas in the cylinder.
Does the ignitor make a sparking noise?
If yes check for spark at burner.
If no spark check for damaged or loose wires.
If wires are OK check for cracked or broken electrode, replace if
needed.
If wire or electrodes are covered by cooking residue, clean
electrode tip with alcohol wipe if needed.
If needed replace wires.
If no sound check battery.
Make sure battery is installed correctly.
Check for loose wire connection at module and switch.
If ignitor continues to not work then use match.
CHAR-BROIL, LLC.
I3B/P(30)
16102040
Butane, Propane or their mixtures
28-30 mbar
Main Burner: 1,10mm
Hotplate: N/A
CZ, DK, FI, IS, IT, NO, NL, SE, SK
4
CAUTION
SPIDER ALERT!
16102041, -CH
Butane, Propane or their mixtures.
Main Burner: 0,99mm
B
Hotplate: N/A
AT, CH, DE, LU, SK
I3B/P(50)
50 mbar
IE GB