Accessories; Standard Accessories - Metabo HPT G 12VE Instructions De Sécurité Et Mode D'emploi

English
CAUTION
● Repair, modification and inspection of
metabo HPT Power Tools must be carried out
by a metabo HPT Authorized Service Center.
This Parts List will be helpful if presented
with the tool to the metabo HPT Authorized
Service Center when requesting repair or other
maintenance.
In the operation and maintenance of power tools,
the safety regulations and standards prescribed
in each country must be observed.
WARNING
Never use any accessories other than those mentioned below.
The use of any accessories other than those mentioned below or attachments not intended for use
such as cup wheel, cut-off wheel or saw blade is dangerous and may cause personal injury or property
damage.
NOTE
Accessories are subject to change without any obligation on the part of the metabo HPT.

STANDARD ACCESSORIES

○ Depressed center wheel (Code No. 316821) .............................................................................................................1
4-1/2" (115 mm) external dia. × 1/4" (6 mm) thickness × 7/8" (22.23 mm) hole dia.
○ Wrench (Code No. 938332Z) .....................................................................................................................................1
○ Side Handle (Code No. 318312) .................................................................................................................................1
○ Hex. Bar Wrench 4 mm (944458) ...............................................................................................................................1
NOTE
Specifi cations are subject to change without any obligation on the part of the metabo HPT.
14
MODIFICATIONS
metabo HPT Power Tools are constantly being
improved and modifi ed to incorporate the latest
technological advancements.
Accordingly, some parts may be changed without
prior notice.

ACCESSORIES