Whirlpool IKEA W11105307A Instructions D'installation page 12

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The Water Dispenser
IMPORTANT:
Dispense at least 1 qt (1 L) of water every week to maintain a
fresh supply.
If the flow of water from the dispenser decreases, it could be
caused by low water pressure.
With the water filter removed, dispense 1 cup (237 mL)
of water. If 1 cup (237 mL) of water is dispensed in 8
seconds or less, the water pressure to the refrigerator
meets the minimum requirement.
If it takes longer than 8 seconds to dispense 1 cup
(237 mL) of water, the water pressure to the refrigerator
is lower than recommended. See the "Water Supply
Requirements" or "Troubleshooting" section for
suggestions.
To Dispense Water:
1. Press a sturdy glass against the water dispenser lever. Hold
the glass close to the water dispenser spout to ensure that the
water dispenses into the glass.
2. Remove the glass to stop dispensing.
IMPORTANT: The small tray at the bottom of the dispenser is
designed to catch small spills and allow for easy cleaning. There
is no drain in the tray.
The Ice Dispenser
Ice dispenses from the ice maker storage bin in the freezer when
the dispenser lever is pressed. To turn off the ice maker, see the
"Ice Maker and Storage Bin" section.
Your ice maker can produce both crushed and cubed ice. Before
dispensing ice, select which type of ice you prefer by pressing
the Crushed/Cubed button.
The display screen indicates which type of ice is selected.
CRUSHED
For crushed ice, cubes are crushed before they are dispensed.
This may cause a slight delay when dispensing crushed ice.
Noise from the ice crusher is normal, and pieces of ice may vary
in size. When changing from crushed to cubed, a few ounces of
crushed ice will be dispensed along with the first cubes.
To Dispense Ice:
1. Press button for the desired type of ice.
WARNING
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
2. Press a sturdy glass against the dispenser lever. Hold the
glass close to the ice guide to ensure that the ice dispenses
into the glass.
IMPORTANT: You do not need to apply a lot of pressure to
the lever in order to activate the ice dispenser. Pressing hard
will not make the ice dispense faster or in greater quantities.
12
CUBED
3. Remove the glass to stop dispensing.
NOTE: Ice may continue to dispense for several seconds after
removing the glass. The dispenser may continue to make
noise for a few seconds after dispensing.
A
C
A. Water dispenser lever
B. Water dispenser spout
C. Ice dispenser lever
D. Ice guide
The Dispenser Light
When you use the dispenser, the light will automatically turn on.
If you want the light to be on continuously, press LIGHT.
Press LIGHT again to turn the dispenser light off. The
dispenser lights are LEDs that cannot be changed. If it
appears that your dispenser lights are not working, see the
"Troubleshooting" section for more information.
The Dispenser Lock
The dispenser can be turned off for easy cleaning or to avoid
unintentional dispensing by small children and pets.
NOTE: The lock feature does not shut off power to the
refrigerator, to the ice maker, or to the dispenser light. It simply
deactivates the dispenser lever. To turn off the ice maker, see the
"Ice Maker and Storage Bin" section.
Press and hold LOCK for 3 seconds to lock the dispenser.
Press and hold LOCK button a second time to unlock the
dispenser.
The display screen indicates when the dispenser is locked.
B
D

Publicité

Table des Matières
loading

Table des Matières