Troubleshooting; Repairs, Spare Parts - XciteRC One12 Série Mode D'emploi

• Also check all connections, cables and power battery / rechargeable battery for damage.
• WARNING: Damaged batteries or rechargeable batteries must not be used again and must be
EN disposed of immediately – fire hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
• WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!

Troubleshooting

Problem
Motor does not
run
Weak motor / no
power
Vehicle is hard to
control
Vehicle has no
function
Vehicle runs very
loud

Repairs, Spare parts

Normal wear and defective parts that result from an accident, are excluded from the warranty. These include
in particular:
for car models: bald tires, worn parts and drive gears, or bent / broken suspension, chassis or bodywork
ship models: damaged or broken propellers, torn superstructure
airplanes: damage due to improper transport or crash
If you find a part that is defective in material or workmanship right after opening the package, return - before
you used it – to your dealer or directly to us and we will send you a replacement.
22
Possible Cause
Motor cable unplugged or broken
Drive battery empty
Motor broken
Battery is almost empty
Drive train does not run smoothly
Vehicle is very loud
Motor gets very hot
Transmitter LED is flashing - transmitter
batteries almost empty
Steering trim ST.TRIM on the transmitter
set incorrectly
Interference
LED on the transmitter does not light up
Transmitter - receiver not bound
Interference
Car aerial torn off
Transmitter LED off - transmitter batteries
almost empty
Drive battery empty
Gear mash between the pinion and main
gear set incorrectly
Worn gears
Bearings runs tight or worn out
Troeubleshooting · Repairs
Solution
Insert the motor cable or solder
Change or charge the battery
Replace the motor
Change or charge the battery
Check drive train and clean if necessary
Check pinion clearance, adjust if neces-
sary
Allow motor to cool; check drive train for
binding parts and precise gear mesh
Change or charge the battery
Check transmitter, set trim correctly
Turn off the vehicle and transmitter, make
a quick break and then re-try
Check that vehicle and transmitter are
turned on
Rebind transmitter - receiver (see chap-
ter BINDING)
Repair antenna (vehicle)
Change or charge the battery
Change or charge the battery
Check gear mesh adjust if necessary
Check and replace if necessary
Check and lubricate or replace if neces-
sary
one12 Serie