Your Oak Stove At A Single Glance; Installation; Lighting The Stove - WANDERS Oak Série Mode D'emploi Et Instructions D'installation

Your Oak stove at a single glance

The Oak is a combination of comfort and e cient heat emission. The large glass panes allow emission of the heat
from the stove directly to the environment to make your room instantly comfortable. The built-in ue gas de ector
ensures circulation of ue gases in the interior parts. Combined with the extra after-burning, it means that the
ue gases have better combustion and reduce the burden on the environment. You can regulate the intake of
combustion air with the integrated air slide valve and adjust the intensity of the re and the output of your stove.

Installation

It is common practice for the dealer where you purchased your Oak stove to also take care of installing it. If this is
not the case, please ensure that the installation is done by a certi ed installer. A certi ed installer can also give you
the right advice about the ue tube to which the stove must be connected. Connecting wood-burning stoves by
unquali ed persons is prohibited, in which case we cannot give any guarantee about proper functioning of your
Oak stove. Please bear the re safety in mind when installing the stove. See also page 23.
The wood-burning stove is suitable as an extra heat source and does not replace your principal heating device,
such as your central heating system.

Lighting the stove

Lighting your stove early in autumn or late in winter
When the external and internal temperatures do not di er much, a proper chimney draught is a challenge. Early
in autumn or late in winter you can help chimney draught get started by burning some wood while keeping all air
inlets maximally open. An abundant air supply speeds up quick heating which in turn increases the draught in the
chimney. Lighting up the stove with only a little wood prevents smoke from streaming into the room.
The stove will become very hot when you light it and will need at least two hours to cool
o . Don't touch the stove without protection during ring and for two hours after. Handle
the stove always with a glove to avoid getting serious burns.
Before lighting the re, you must clean away any deposits on the window pane with a paper
from a kitchen roll. The same paper can be used for lighting the re.
Open the combustion air inlet. Open the slide to its maximum before lighting the stove.
Then open the door and put some balls of paper or relighters in the stove and place some
wood kindling on top. Light the kindling and leave the stove door ajar (for 3 to 5 minutes)
17