Installing The Drain Plumbing; Gravity Drain - AGA marvel MA15CL Instructions D'installation, D'utilisation Et D'entretien

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

CAUTION

Failure to use an adequate drainage system, will result in

surrounding water damage and/or poor ice production.

WARNING

Electrical Shock Hazard

Reasonable care and safe methods should be prac-

ticed. Do NOT work with energized electrical equip-

ment in a wet area. Read and follow the installation

instructions listed in this manual.

Drain Plumbing

Your ice machine requires drain plumbing. There are 2

variations of ice machines in regards to the installation of

the drain plumbing, without a drain pump (gravity drain),

and with a drain pump.

Gravity Drain (no drain pump):

The ice machine is shipped with the drain line installed,

coiled and secured to the back of the cabinet as shown

in Figure 7. It can be uncoiled, routed to an appropriate

drain and cut to length as required. Additionally there is the

provision of drain routing through the cut-out in the bottom

of the unit, (see the gray area in Figure 8). A drain can be

installed in this gray area with the drain line cut to a short

length and positioned into the drain as shown in Figure 9,

or if the ice machine is to be built-in, the drain tube could be

routed through a hole in the floor in this gray area to a drain

below.

CAUTION

The gravity drain line must be routed no higher than 6"

(15.2 cm) off the floor to assure proper drainage.

Figure 7

Uncoil the drain line, route

to an appropriate drain and

cut to the required length