AGA marvel MA15CL Instructions D'installation, D'utilisation Et D'entretien page 21

Step 5: Drill necessary handle holes and
mount handle:
This is a convenient time to locate and drill the holes for
your handle. Most often the handle is to match that of the
surrounding cabinetry. If your handle attaches from the
back-side of the custom panel, locate the mounting holes
while the panel is attached to the door and cabinet. After
the panel is removed from the door, drill the mounting holes
from the front, to the recommended diameter of the handle
manufacturer. Counter bore the back-side of the panel so
the screw heads do not interfere with the surface of the
door.
Top hinge
adapter
Figure 30
OVERLAY DOOR PANEL INSTALLATION
Hole in
hinge
adapter
Door
Overlay
panel
Hole in bottom
hinge adapter
Step 6: Drill panel mounting holes
Re-clamp the panel to the door per step 5 and drill the
screw pilot holes for attaching the overlay panel to the door.
Select the size of the hole from Table A. Be careful not to
drill the pilot holes through the overlay panel,
deep for ⁄ " (19 mm) and
3
4
Step 7: Secure overlay panel to the door.
With the #10 wood screws provided, fasten the overlay
panel to the door. (See Figure 31).
Material Type
Hardwood
Softwood
Clearance hole through
door gasket channel
#10 Wood Screw
Back of door
21
⁄ " (12.7 mm)
1
2
⁄ " (15.7 mm) panels.
5
8
#10 Wood Screw
⁄ " (3.2 mm) Diameter Pilot Hole
1
8
⁄ (2.8 mm) Diameter Pilot Hole
7
64
Table A
Figure 31