Table des Matières
Publicité
10
02
06
14
VAL P 19
05
91
04
FIG. 2
DIE REPLACEMENT
INSERTION DES MATRICES
EINRASTEN PRESSEINSÄTZE
INSERCION DE LAS MATRICES
INSERIMENTO MATRICI
FIG. 3
STORAGE
RANGEMENT
LAGERUNG
ALMACENAMIENTO
CUSTODIA
33
2.7) Battery status
After releasing the operating button, the residual battery capacity is automatically displayed
for 5 seconds. The number of LEDs illuminated indicates the residual capacity:
8 leds illuminated: Fully charged
4 leds illuminated: 50 % capacity
1 led illuminated: Minimum charge
When replacing the battery press the two points marked with the word "PUSH" at the
90
same time, remove the fl at battery from its housing and insert the new one.
2.8) Power from an external source
Using the integral socket (23) the tool can be powered from a external power supply
(min. 20A) or vehicle battery (Ref. to Fig. 4).
Using the special connection cable type ESC 600, available as an optional accessory,
proceed as follows:
– Make sure the supply voltage is between 12 and 14,4 V DC.
– Connect the spring clips to the external supply ensuring correct polarity, red to positive
pole (+), black to negative pole.
– Remove the cap (22) from the socket (23) on the tool and insert connector (93), tightening
the bezel clockwise until it locks.
– When the work is fi nished, disconnect the cable (93) and replace the protective cap (20).
Should the poles be accidentally reversed, the tool will not be damaged but will operate us-
ing only the integral battery (19). For rectifi cation, reverse the polarity of the spring clips.
W
HEN USING AN EXTERNAL POWER SUPPLY
CONTACTS INSIDE THE BATTERY HOUSING
IN ITS HOUSING AS IT WILL SUPPLY POWER IN PARALLEL WITH THE EXTERNAL SOURCE
3. WARNING
T
HE TOOL IS UNSUITABLE FOR CONTINUOUS USE AND SHOULD BE ALLOWED TO
COOL DOWN FOLLOWING UNINTERRUPTED
HAVING EXHAUSTED A FULLY CHARGED BATTERY IN ONE SESSION
REPLACEMENT FOR A FEW MINUTES
O
BSERVE RECOMMENDED REST PERIODS ALSO WHEN USING AN EXTERNAL POWER
.
SUPPLY
D
O NOT ATTEMPT TO ROTATE THE HEAD WHEN THE HYDRAULIC CIRCUIT IS PRES
.
SURISED
P
ROTECT THE TOOL FROM RAIN AND MOISTURE
AND BATTERY
RAIN OR UNDER WATER
6
(Ref. to Fig. 1)
(only for B131-C/CA)
,
NEVER SHORT CIRCUIT THE METAL
.
WE ADVISE LEAVING THE BATTERY
,
SUCCESSIVE OPERATIONS
.
. W
ATER WILL DAMAGE THE TOOL
. E
-
LECTRO
HYDRAULIC TOOLS SHOULD NOT BE OPERATED IN POURING
.
ENGLISH
(19)
.
;
,
FOR INSTANCE
,
DELAY BATTERY
-
Publicité
Table des Matières
