PACLITE Equipment CRX60H Manuel De L'opérateur page 10

1. Open the fuel cock.
2. Set the engine switch to the ON position.
3. Set the speed control lever to the STARTING position (Halfway between HIGH and LOW position).
4. Move the choke lever to the CLOSED position.
5. Taking a firm hold of the Operating handle with one hand, grasp the recoil starter handle with the other,
Pull the recoil starter handle until engine resistance is felt, then let starter return.
6. Taking care not to pull the starter rope fully out, pull the starter handle briskly.
7. Repeat until the engine fires.
8. Once the engine fires gradually set the choke lever to the OPEN position.
9. Let the engine run at idle for a few minutes to warm up.
10. After the engine has warmed up, the machine is ready for operation.
11. Move the throttle lever to the high speed 'H' position quickly to prevent damage from occurring to
the clutch. The 'Full Throttle' position of this machine has been preset at the factory to achieve
optimum machine performance.
12. With the engine running in the full throttle position, the machine will move forward and compact
loose 'lifts'
13. In preparation for stopping the engine, move the throttle lever to the LOW position.
14. Allow the engine to idle for 1-3 minutes.
15. Set the engine switch to the OFF position. Do not touch the HOT engine part at this time.
16. Close the fuel cock.
17. Pull the recoil starter slowly until you feel resistance. Then release your hand from the starter knob
to set it back to its original position. This will prevent any air or humidity from entering into the cylinder.
Model
TR-600
CRX68
TR-670
TR-740
The Max rpm as shown above is the number of ignitions per minute. GX120K1 engine for the TR-670
have the final gears at the ration of 17/16, and the number of ignitions per minute is different from the
number of rotations of the engines Power Take-Off Shaft.
8
Engine
Honda GX100
Honda GX120
Honda GX120
Maximum RPM
Optimum
3,800 +/- 50
3,400 +/- 50
3,400 +/- 50
Upper Limit
4,000
3,450
3, 450