Oscartielle SATURNO Mode D'emploi page 19

Warning: Never approach the motor compartment in the event of leaking gas or a fire. Unplug at the mains. Never
use water to put out any flames, but only dry powder extinguishers. All the materials used to build the unit are fire-
proof or self-extinguishing and non-flammable.
13 - Accessories
SATURNO displays can be fitted with the following accessories on request.
- Night blinds.
- Row dividers.
- Raised edges in tempered glass for display shelves.
- Shelf illumination.
- Price holders in aluminium or plastic.
- Electric defrosting (armoured resistances on the evaporator).
If you are interested in purchasing any of the above accessories, contact your nearest dealer or the manufacturer
directly. Only qualified personnel should assemble the electric defrosting units.
14 - Customer service
If you need the assistance of expert service personnel, or if any mechanical, electrical or compressor components
need to be replaced, please contact the dealer from whom you bought the unit and ask for original spare parts.
15 - Dismantling and elimination of cabinet
For environmental reasons and in compliance with the regulations in your country, separate the parts of the cabinet for
disposal and/or recycling.
All the parts that make up the cabinet are made of materials that are not classifiable as urban waste except for the
metallic parts that are not classified as special waste in most countries. As regards the parts of the refrigeration circuit,
that is the refrigerating gas and lubricating oil, these should not be disposed of carelessly and can be recycled by
specialized centers.
This product contains HFC, namely fluoridated gasses, a refrigerating gas with a high Global Warming
Potential (GWP) regulated by the Kyoto protocol.
The gas contained in foam polystyrene for thermal insulation of the cabinet is (R134A).
Oscartielle equips its plug-in cabinets with the following types of refrigerating gasses:
R 134a; GWP = 1300
(100)
R 404A; GWP = 3750
(100)
This unit is hermetically sealed and the refrigerating gas load is under 3 kg.
For this reason it is not subject to the requisite of an installation booklet and periodic inspections for leakage
of the refrigerating gas (presidential Decree no. 147 of February 15th 2006, Art. 3 and 4).
16 - Manufacturer's declaration (Start-up prohibition)
The above models are also built to be assembled in line with other items of machinery to produce a machine, as
defined by EEC Directive 89/392. Therefore, the Manufacturer hereby states that the cabinet may not be started up
until the machine in which it is incorporated or will become a part of has been identified and its compliance with the
provisions of EEC Directive 89/392 and applicable national laws has been ascertained, in other words, until the
machine referred to in this statement becomes one with the final machine.
17 - Multiplexing instruction
To multiplex two or more Saturno cabinets, follow the instructions below (FIG. 16 page 5).
1) Draw the cabinets close and intervene on feet, in order to obtain a perfect alignment (Ref. 1).
2) Insert three iron pins Ø 4x40 in the aluminium profile on basin front (Ref. 2a).
3) Hook basements using four threaded bars M8x125, eight nuts and eight washers (Ref. 3).
4) Remove the bottom shelves and the back ones. Join the uprights using 2 screws Ø 6x50 and nuts (Ref. 4). Before
joining the two counters definitively, it is better to seal end panels using an appropriate silicone.
5) Join basins using two screws 8x60 and their nuts. Join the external top ceilings of the cabinets by two brackets
(Ref. 5a). Join the two basin fronts using another bracket (Ref. 2b).
18 - Wiring diagrams
The wiring diagram can be seen on page 6 - FIG.18a and page 7 - FIG. 18b.
19 - Conformity Declaration
A copy of the declaration of product conformity can be requested by filling in the form available a the internet address:
http://www.oscartielle.it/conformity
17