Operation And Maintenance - Amica AH3016 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

The cooker hood can be controlled using a control panel (Fig. 4...)

Speed Selection The product has 5 speeds of ventilation level. One of 1,2,3,...5 speeds is selected

in accordance with steam of cooking or fry. Motor is started pressing

panel. Speed is increased pressing button >, and decreased by pressing button >. Automatic timer

(TIMER) is available at the models with electronic remote control.

When you press

timer is on, Display will signal and the motor will be off automatically 15 minutes later. Please use

the cooker and the product at the same time to enable circulation. Doing so, air suction power will

be affected positively. We recommend you to operate your product for few minutes more after the

cooking is completed to enable absorption rest of smell and steam.

Illumination

The product has 2 lamps and one lamp button to operate illumination. Press lamp

to start illumination.

NOTE: If your product has dimmer function please pay attention to the explanation stated below.

Changing Brightness of the Lamp (Dimmer):

When the lamp is on, lamp's brightness starts to change continuously if you keep lamp button pres-

sed. When you get the brightness level that you wish and stop pressing the button, brightness that

is set will be recorded, and the product will start with the same brightness during next usage. When

you press the lamp button 2 times consecutively, the lamp will be on at the highest brightness level.

The lamp will always start at the brightness level that is set during last usage.

CleanIng Periods of the Aluminum Filters:

Filters should be cleaned when " " signal appears on Display or (according to usage) each 2-3

weeks. In order to remove " " signal, after the filters are cleaned and replaced to their place, press

button more than 3 seconds (when the product is at off position). Letter "E" will appear on Display

and the product will operate as normal. If you would like to continue using the product without dele-

ting " " signal, when you press the

will appear once more and the motor will continue operating.

NOTE: " " signal will appear after usage of the product for 60 hours.

Remote control unit (Fig. 4b)

Your cooker hood can be controlled by a remote control unit. Remote control unit functions are

described below:

1. Turn the fan on/off

2. Reduce cooker hood fan speed

3. Increase cooker hood fan speed

4. Turn the light on/off

Press the POWER button to turn on the cooker hood fan. The fan will run at speed 2. The hood light

can be switched on independently from the "POWER" button.

To use the remote control unit:

Insert batteries in the remote control by removing the battery compartment cover on the back of the

remote control unit.

Place the new batteries in the remote control unit according to the markings inside the battery com-

partment.

Close the battery cover.

Point the remote control unit toward the front of the cooker hood.

Ensure there are no obstacles between the remote control transmitter and the sensor on the cooker

hood. Fluorescent light can interfere with the remote control operation.

Batteries for the remote control are not included. Batteries can be purchased in any corner shop or

retail outlet.