Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Check before starting
Li-ion
Li-ion
•
Check the motor for dirt and cracks. Clean off grass
and leaves from the engine using a brush. Gloves
should be worn when necessary.
•
Check that the saw head is attached firmly to the
shaft.
•
Check that the machine is in perfect working order.
Check that all nuts and screws are tight.
•
Ensure that the saw head is not damaged and there
are no cracks. Replace the saw head if it has been
exposed to impact or is cracked.
•
Never use the machine without a guard nor with a
defective guard.
•
All covers must be correctly fitted and undamaged
before you start the machine.
•
Only use the machine for the purpose it was intended
for.
Connect battery to the machine
Make sure to use fully charged batteries. Use only a
Husqvarna original battery in your machine. See technical
data.
•
Insert the battery in the machine. The battery should
slide easily into the battery holder on the machine. If
the battery does not slide in easily, it is not being
inserted correctly. The battery will lock itself into place
when you hear a click. Make sure the battery is fitted
correctly to the machine.
22 – English
STARTING AND STOPPING
Starting and stopping
WARNING! Make sure no unauthorised
!
persons are in the working area,
otherwise there is a risk of serious
personal injury. The safety distance is 15
meters (50 ft.).
Starting
Turn on the machine. Press and hold the start button (>1
sec.) until the green LED is lit.
Use the power trigger to control the speed.
NOTE!
Start the pole saw and apply full throttle. Release the
throttle control and check that the chain stops and
remains stationary.
Stopping
Stop the machine by releasing the power trigger or the
power trigger lockout and deactivate the machine.
Remove the battery from the machine by pressing the two
release buttons and pulling out the battery.
IMPORTANT! Always remove the battery to prevent the
machine being started by accident.
Publicité
Chapitres
Table des Matières
