Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
9. enD pAnel inSTAllATion - continued
D. At the bottom, where the webbing exits the pocket on each side of end panel, pull webbing as you would a
drawstring to remove the slack. Be careful not to pull the webbing strap out of the webbing pocket.
pUll
E. Insert the "S"- Hook on ratchet into hole on the leg bend. Insert the webbing into the spindle of the ratchet
and pull tight. Wind the ratchet so that the webbing overlaps itself. Position the end panel so that it is
centered on the building before fully tightening the end panel.
F. Tighten ratchets, alternating from one side to the other, until the end panel is tight. NOTE: keep zippers
closed when tightening door panel.
e
WEBBING
STRAP
Insert Webbing into
Ratchet
F
Page 9
D
END PANEL vIEW
FROM INSIDE
AUTOSHELTER
pUll
05_62684_0B
Publicité
Table des Matières
