Intended Use; Ec Declaration Of Conformity; Instruction Manual - Makita DTD154 Manuel D'instructions

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Fastening capacities
No load speed
Impacts per minute
Rated voltage
Overall length
Battery cartridge
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003

Intended use

The tool is intended for screw driving in wood, metal
and plastic.
Noise
The typical A-weighted noise level determined accord-
ing to EN60745:
Sound pressure level (L
Sound power level (L ) : 107 dB (A)
WA
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
WARNING:
Wear ear protection.
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN60745:
Work mode: impact tightening of fasteners of the maxi-
mum capacity of the tool
Vibration emission (a ) : 12.5 m/s
h
Uncertainty (K) : 1.5 m/s
Machine screw
Standard bolt
High tensile bolt
Hard impact mode
Medium impact mode
Soft impact mode
T mode
Hard impact mode
Medium impact mode
Soft impact mode
T mode
) : 96 dB(A)
pA
2
2
BL1815, BL1815N, BL1820,
BL1820B
1.2 kg
NOTE: The declared vibration emission value has
been measured in accordance with the standard test
method and may be used for comparing one tool with
another.
NOTE: The declared vibration emission value
may also be used in a preliminary assessment of
exposure.
WARNING:
The vibration emission during actual
use of the power tool can differ from the declared
emission value depending on the ways in which the
tool is used.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).

EC Declaration of Conformity

For European countries only
The EC declaration of conformity is included as Annex A
to this instruction manual.
5 ENGLISH
DTD154
4 mm - 8 mm
5 mm - 16 mm
5 mm - 14 mm
-1
0 - 3,600 min
-1
0 - 2,100 min
-1
0 - 1,100 min
-1
0 - 3,600 min
-1
0 - 3,800 min
-1
0 - 2,600 min
-1
0 - 1,100 min
-1
0 - 2,600 min
D.C. 18 V
117 mm
BL1830, BL1830B, BL1840,
BL1840B, BL1850, BL1850B,
BL1860B
1.5 kg