Danby DFF100C1BSLDB Guide D'utilisation Et Soins De Propriètaire page 8

Installation Instructions
CHANGING LED LIGHT
Please follow the steps below
We recommend that you start by unplugging your refrigerator unit.
1. Take off the light cover by flicking the bottom tab up (the bottom tab is located at the bottom middle of
the light cover).
2. Take out the LED display by pulling it down and unhooking it from the port, it is best to use your thumb
on the front of the LED and you fingers at the back near the port.
3. Put in the new LED by inserting it into the port.
4. Once the LED is secured, put the cover back on by inserting the two top tabs in to their slots and push-
ing the bottom tab back into place, you should hear a quiet click.
Once you have secured the light cover back on, you can plug your refrigerator back in.
Take off the light cover by
flicking up bottom tab
1
Unhook the LED display
using your thumb and fingers
You will see the LED display
2
Bottom tab
Hook the new LED display to the
port
Pull the LED display down
5
Put the cover
Top tabs
back on