Fault Codes - Inventum VVW7040BS++ Manuel D'utilisation

Problem
The dishes are not dry.
There are rust stains on the dishes.

FAULT CODES

The fault codes are shown on the display of the control panel.
Fault code Possible cause
F5 There is insufficient water supply.
F3 The water supply does not stop.
F2 The waste water in the appliance cannot
be discharged.
F8 The heater has an error.
F1 The safety for water overflow is
activated.
F7 The temperature of the appliance is too
high.
F6 The heat sensor has an error.
FE There is an electronic error.
Possible cause
The selected program does not
include drying.
The level of rinse aid consumption is
set too low.
The stainless steel quality of the
dishes is insufficient.
There is a high level of salt in the
water.
The cap of the salt reservoir is not
closed correctly.
Any spilled salt during filling of the
salt reservoir was not cleaned
immediately.
There is a problem with the
grounding of the mains supply.
Possible solution
• Make sure that the water tap is fully open and that
the water supply is not blocked.
• Close the water tap, remove the water inlet hose and
clean the filter of the hose.
• Contact the Inventum-servicedienst if the fault code
keeps re-occuring.
• Close the water tap.
• Contact the Inventum-servicedienst.
• Do a check if the drain hose is clogged.
• Do a check if the filters are clogged.
• Reset the program. Refer to section
program'
• Contact the Inventum-servicedienst if the fault code
keeps re-occuring.
Contact the Inventum-servicedienst.
• Disconnect the mains plug and close the water tap.
• Contact the Inventum-servicedienst.
Contact the Inventum-servicedienst.
Contact the Inventum-servicedienst.
Contact the Inventum-servicedienst.
Possible solution
Choose a program that includes
drying. Refer to section
Adjust the level of rinse aid
consumption. Refer to section
'Setting the level of rinse aid
consumption'
.
Make sure that you only clean
dishwasher-safe dishes in the
appliance.
Adjust the level of salt consumption.
Refer to section 'Setting the level of
salt consumption'
.
Make sure that the cap of the salt
reservoir is closed firmly.
Make sure that you clean any spilled
salt immediately and run a full
program to prevent corrosion.
Contact an authorized electrician.
.
English
'Programs'
.
'Resetting the
• 55