Fault Codes - Inventum VVW7040++ Manuel D'utilisation

Problem
There are white stains on the dishes. The amount of detergent is
The dishes are not dry.
There are rust stains on the dishes.

FAULT CODES

The fault codes are shown on the display of the control panel.
52 • English
Possible cause
One of the spray arms is clogged.
The filters are clogged.
The filters are not placed correctly.
The water drain pump is clogged.
insufficient.
The level of rinse aid consumption is
set too low.
There is a high level of water
hardness and no salt is used.
The cap of the salt reservoir is not
closed correctly.
The selected program does not
include drying.
The level of rinse aid consumption is
set too low.
The stainless steel quality of the
dishes is insufficient.
There is a high level of salt in the
water.
The cap of the salt reservoir is not
closed correctly.
Any spilled salt during filling of the
salt reservoir was not cleaned
immediately.
There is a problem with the
grounding of the mains supply.
Possible solution
Clean the spray arms. Refer to
'Cleaning the spray arms'
section
Clean the filters. Refer to section
'Cleaning the filters'
.
Make sure that you correctly place
the filters.
Make sure that the water drain pump
is not clogged.
Make sure that you fill the detergent
reservoir with a sufficient amount of
detergent. Refer to section
the detergent reservoir'
.
Adjust the level of rinse aid
consumption. Refer to section
'Setting the level of rinse aid
consumption'
.
Fill the salt reservoir. Refer to
section 'Filling the salt reservoir'
Make sure that the cap of the salt
reservoir is closed firmly.
Choose a program that includes
drying. Refer to section 'Programs'
Adjust the level of rinse aid
consumption. Refer to section
'Setting the level of rinse aid
consumption'
.
Make sure that you only clean
dishwasher-safe dishes in the
appliance.
Adjust the level of salt consumption.
'Setting the level of
Refer to section
salt consumption' .
Make sure that the cap of the salt
reservoir is closed firmly.
Make sure that you clean any spilled
salt immediately and run a full
program to prevent corrosion.
Contact an authorized electrician.
.
'Filling
.
.