Inventum VVW6008AW Manuel D'utilisation page 51

Problem
The detergent reservoir contains
detergent residues.
The appliance contains water when
the program is finished.
The appliance stops during a
program.
The appliance makes unusual
sounds during a program.
There is food waste left on the
dishes.
There are white stains on the dishes. The amount of detergent is
Possible cause
The detergent reservoir is filled while
the reservoir was still damp.
The drain hose is clogged or twisted. •
The filters are clogged.
The program has not finished.
There is a power failure.
There is a water inlet failure.
One of the spray arms hits the
dishes.
The appliance is not loaded correctly
and the spray arms cannot reach all
the dishes.
The appliance is not loaded
correctly.
The amount of detergent is
insufficient.
The selected program is not suitable
for the loaded dishes.
One of the spray arms is clogged.
The filters are clogged.
The filters are not placed correctly.
The water drain pump is clogged.
insufficient.
The level of rinse aid consumption is
set too low.
There is a high level of water
hardness and no salt is used.
Possible solution
Make sure that you fill the detergent
reservoir when it is dry.
Make sure that the drain hose is
not clogged.
• Make sure that the drain hose is
not twisted.
Clean the filters. Refer to section
'Cleaning the filters' .
Wait until the program is finished.
A buzzer sounds five times and the
ready indicator is on when a program
is finished.
Make sure that there is power.
Make sure that there is water inlet
supply.
Make sure that you load the
appliance correctly. Refer to section
'Loading the appliance'
.
Make sure that you load the
appliance correctly. Refer to section
'Loading the appliance'
.
Make sure that you load the
appliance correctly. Refer to section
'Loading the appliance'
.
Make sure that you fill the detergent
reservoir with a sufficient amount of
detergent. Refer to section
the detergent reservoir'
.
Choose a suitable program. Refer to
'Programs'
section .
Clean the spray arms. Refer to
section 'Cleaning the spray arms'
Clean the filters. Refer to section
'Cleaning the filters'
.
Make sure that you correctly place
the filters.
Make sure that the water drain pump
is not clogged.
Make sure that you fill the detergent
reservoir with a sufficient amount of
detergent. Refer to section
the detergent reservoir'
.
Adjust the level of rinse aid
consumption. Refer to section
'Setting the level of rinse aid
consumption' .
Fill the salt reservoir. Refer to
'Filling the salt reservoir'
section
English
'Filling
.
'Filling
.
• 51