Assembly; Unpacking The Generator; Carton Contents; Install Wheel Kit - Briggs & Stratton PRO6500 Manuel D'utilisation

ASSEMBLY

Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-743-4115.

Unpacking the Generator

1. Set the carton on a rigid flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner from
top to bottom.
4. Leave generator on carton to install wheel kit.

Carton Contents

Check all contents. If any parts are missing or damaged, call
the generator helpline at 1–800–743–4115.
• The generator
• Generator operator's manual
Figure 1 — Install Wheel Kit
Nylon Washer
45 mm Cap Screw
Flat Washer
Handle
Use existing hardware
to attach left side of
support leg to unit
Handle Pin
Nylon Washer
Nut
Nut
Vibration Mount
3/4" Cap Screw
BSPP Generator
• Engine operator's manual
• (2) Locking 30A plugs
• Battery charge cables
• Engine oil
• Wheel kit

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use.
You will need the following tools to install these
components:
• 7/16" and 13mm wrench
• Socket wrench with a 13mm and a 7/16" socket
• Pliers
• Safety glasses
Refer to Figure 1 and install the wheel kit as follows:
1. Tip generator so that engine end is up.
2. Slide axle through both mounting brackets.
3. Place a wheel on each side with air valve facing out.
4. Place a washer on axle and then place an e-ring in axle
groove.
Axle
20 mm Cap Screw
Support Leg
Nut
6
Your unit may vary slightly
from that shown here
Wheel
Flat Washer
E-Ring