Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation/Connection
Part list for installation
(A) Wiring harness (×1)
(B) Flat head screw, M5 × 8 mm (M5 × 3/8") (×8)
(C) Round head screw, M5 × 8 mm (M5 × 3/8") (×8)

Basic procedure

1 Remove the key from the ignition switch, then disconnect
the
terminal of the car battery.
2 Connect the wires properly.
See "Wiring connection" on page 44.
3 Install the unit to your car.
See the following "Installing the unit (in-dash mounting)".
4 Connect the
terminal of the car battery.
5 Press SOURCE B to turn on the power.
6 Reset the unit. (Page 4)
Installing the unit (in-dash mounting)
Install onto the car brackets using the supplied screws (B) or (C). The screw holes differ depending on the model of the cars.
Do the required wiring. (Page 44)
Dashboard of
your car
* Only for illustration purpose.
Use only the specified screws. Using wrong screws might damage the unit.
Car bracket*
ENGLISH
43

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Kw-x840bts

Table des Matières