JVC KW-R940BTS Manuel D'instructions page 29

Bluetooth®
[PHONEBOOK] (Applicable only if the phone supports PBAP.)
1 Press 1 J / 2 K to select the desired letter (A to Z, 0 to 9, and OTHERS).
• "OTHERS" appears if the first character is other than A to Z, 0 to 9.
2 Turn the volume knob to select a name, then press the knob.
3 Turn the volume knob to select a phone number, then press the knob to
call.
• For using phonebook with this unit, make sure to allow access to or transfer
from your smartphone. Depending on the connected phone, the process
may be different.
• This unit can display only non-accent letters. (Accent letters such as "Ú" are
showns as "U".)
[DIAL NUMBER] 1 Turn the volume knob to select a number (0 to 9) or character
( , #, +).
2 Press S / T to move the entry position.
Repeat step 1 and step 2 until you finish entering the phone number.
3 Press the volume knob to call.
[VOICE] Speak the name of the contact you want to call or the voice command to
control the phone functions. (See also the following "Make a call using voice
recognition".)
Make a call using voice recognition
1 Press and hold to activate the voice recognition of the
connected phone.
2 Speak the name of the contact you want to call or the voice command
to control the phone functions.
• Supported Voice Recognition features vary for each phone. Refer to the
instruction manual of the connected phone for details.
Store a contact in memory
You can store up to 6 contacts into the number buttons (1 to 6).
1
Press to enter Bluetooth mode.
2
Turn the volume knob to select [RECENT CALL], [PHONEBOOK] or
[DIAL NUMBER], then press the knob.
3
Turn the volume knob to select a contact or enter a phone number.
If a contact is selected, press the volume knob to show the phone
number.
4 Press and hold one of the number buttons (1 to 6).
"MEMORY P(selected preset number)" appears when the contact is
stored.
To erase a contact from the preset memory, select [DIAL NUMBER] in step 2,
store a blank number in step 3 and proceed to step 4.
Make a call to a registered number
1 Press to enter Bluetooth mode.
2
Press one of the number buttons (1 to 6).
3
Press the volume knob to call.
"NO PRESET" appears if there is no contact stored.
Bluetooth mode settings
1
Press and hold MENU.
2 Turn the volume knob to select an item (page 24), then press the
knob.
3 Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
4
Press MENU to exit.
To return to the previous setting item, press .
23
ENGLISH