WAGNER ProSpray 3.25 Mode D'emploi page 33

Volume Pumped Screen
The Volume Pumped screen shows the
total number of gallons or liters sprayed by
the sprayer.
To select the Volume Pumped screen, press
Job Volume Screen
The Job Volume screen allows the user
to reset a liter counter to track usage on
speci c jobs.
To select the Job Volume screen, press the
Unit Serial # Screen
serial number.
Timers Screen
The Timers screen shows the total time the
sprayer has been turned on as well as the
total time the sprayer has been running (pumping).
key.
Job Timers Screen
The Job Timers screen allows the user to
track time on speci c jobs.
To select the Job Timers screen, press the
to scroll through the remaining menu
screens.
Service Time Screen
The Service Time screen allows the user to
set a service time interval (in hours). Below
the set time, the screens shows the current amount of hours on the
sprayer since the last activation of the service timer. To select the
time (run hours will increase/decrease in increments of 25 for each
time you press a key).
When the service time interval is set and met by the run hours, the
will reset the "Service @" and "Run Hours" displayed on the Service
Screen back to 0.
ProSpray 3.25
GB
VOLUME PUMPED
MENU-1 SELECT-4
GALLONS X
MENU-1 LITRES-2
LITRES X
MENU-1 GALLONS-2
JOB VOLUME
MENU-1 SELECT-4
GALLONS XXXX
MENU-1 RESET-3
UNIT SERIAL #
MENU-1 SELECT-4
SER # XXXXXXXXXX
MENU-1
TIMERS
MENU-1 SELECT-4
ON TIME XXXX
RUN TIME XXXX
JOB TIMERS
MENU-1 SELECT-4
JOB ON X
MENU-1 RESET-3
JOB RUN X
MENU-1 RESET-3
SERVICE TIME
MENU-1 SELECT-4
SERVICE @ XX
RUN HOURS XX
31
Security Code Screen
The Security Code screen allows the user
to set a four digit security code to prevent
unauthorized use of the sprayer. If a security code has been set, the
control system display will ask for the code at startup. If the correct
sprayer will operate. If the wrong code is entered, the display will
continue to ask for the correct code and the sprayer will be disabled.
If the sprayer is new, no security code is set and the
i
Main Screen will appear at startup. When setting a
security code for the rst time, the "Enter Old Code
Number" screen will appear, and you will need to
enter "1111".
Enter the old security code number to
access the screen that allows the code
change. If the wrong code is entered, the display will continue to ask
for the correct code and the security code cannot be changed.
new code is entered, the display will
automatically ask that the new code be
re-entered for veri cation. If the same new
code is re-entered, the display will con rm
that the new code has been accepted and
If you forget or misplace your security code, you can contact Wagner
customer service for assistance.
To inactivate the security function, enter "1111" at
i
the "Enter New Code Number" screen (this is the
default code that leaves the sprayer unlocked). As
a result, the Main Screen will appear at sprayer
startup.
Prime Screen
The Prime screen appears when the
setting.
Rapid Clean Screen
The Rapid Clean screen appears when the
pressure control knob is set at the RAPID
i
If there is no action at any menu screen for 30
seconds, the display will go back to the Main Screen.
Starting operation
SECURITY CODE
MENU-1 CHANGE-2
ENTER OLD CODE
NUMBER
ENTER NEW CODE
NUMBER XXXX
RE-ENTER NEW
NUMBER XXXX
NEW CODE NUMBER
ACCEPTED
PRIME
RAPID CLEAN