2. SAFETY INSTRUCTIONS
The manufacturer accepts no liability for damage in the following cases:
•
Faulty installation or connection
•
Damage to the product resulting from mechanical factors and/or incorrect connection voltage
•
Alterations to the product without express permission from the manufacturer
•
Use for purposes other than those described in the operating manual
WARNING!
•
Do not operate the incineration toilet if it is visibly damaged.
•
If the DC power cable for this toilet is damaged, it must be replaced by the manufacturer, customer service
or a similarly qualified person in order to prevent safety hazards.
•
Never use a naked flame to check the toilet gas connections for any leakage.
•
This toilet may only be repaired by qualified personnel, Inadequate repairs may cause serious hazards
•
Only use propane gas (not natural gas).
•
Only operate the toilet with the pressure shown on the type plate on the back of the toilet.
CAUTION!
•
Danger of crushing! Do not place your hand on the hinge or underneath the toilet seat and lid while open, as
there is no soft-close function on the lid and seat.
•
Do not empty the ash container when hot.
•
Before activating, ensure that the power supply line and plug are dry.
NB!
•
During transport, only hold the toilet by the toilet shell. Never hold the toilet by the gas connection, power
cord, front cover, lid or seat or exhaust outlet.
•
Check that the voltage specification on the type plate is the same as that of the energy supply.
•
Only use power cables with a suitable cross section, according to the energy conspumption stated on the
type plate.
•
Danger of overheating!
Always ensure sufficient ventilation so that the heat and emissions generated during the incineration can
dissipate from the ventilation pipe. Ensure proper air flow for the system.Always ensure sufficient ventilation
into the room where the toilet is installed. Make sure that the toilet is sufficiently far away from walls or
other objects so that the air can circulate.
4