Finalizing The Installation; Transport Safety Strap - Cinderella Comfort NA Manuel D'installation

Finalizing the Installation

Install the required fittings. If the outlet pipe is installed up a wall,
fittings for attaching the pipe to the wall may be required.
The supplied T-piece should always be used. The plug on the T-piece
must always be located at the underside since there is an exit hole for
moisture on the underside of the T-piece. Because of this, the T-piece
should not be enclosed, as it is necessary to inspect the exit hole to
make sure it is not blocked by leaves or similar objects. In cases where
T-pieces must be enclosed, an inspection hatch must be installed.
If the T-piece is installed indoors, you can place a bowl underneath to
collect any moisture. Push the supplied ventilator cowl onto the pipe
until it stops.
NOTE:
Do not install a mosquito net over the end of the outlet air
pipe. Cinderella may be secured to the floor using suitable fixing mate-
rials; see fig. 15.

Transport safety strap

The ash container is equipped with a
safety strap which must be removed before use as
follows:
1. Remove the front cover.
2. Cut away the plastic straps attaching the ash con-
tainer to the steel frame.
3. Remove the plastic straps.
fig. 15
Transport safety strap
IMPORTANT
Extension cords should not be used with this
appliance.
In order to attach the Cinderella Comfort
to the floor: Remove the ash container.
Drill holes through the indicated mounting
holes. Use wood or machine screws as
appropriate, depending on the type of floor.
11