Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7. INLET AIR
The air inlet vent should preferably be installed as close to the
Cinderella toilet as possible, to ensure a good air supply to the toilet
and reduce the environmental impact in the toilet room. It is important
that there are no other air-dependent installations used at the same
time as the toilet, e.g. an extractor fan or fireplace. The Cinderella GAS
toilet draws air mainly from the underside of the toilet. It is therefore
possible to have the air intake underneath the toilet. This allows you
to insulate the air as much as possible in the toilet and minimise the
environmental impact in the toilet room.
7.1 INLET AIR SPECIFICATIONS
•
The inlet vent's minimum dimensions must be 160 mm diameter/
201 cm². We recommend that you use the supplied vent.
•
The vent must be open at all times. Remember to clean the vent at
regular intervals.
•
Make sure that there is no conflict between the toilet's air supply and
other installations, such as a fireplace or extractor fan.
•
Do not use a separate ventilation fan or similar to extract air from the
room where the toilet is installed when using the
Cinderella GAS toilet.
•
If you have open ventilation under the toilet, it may be advisable to use a
mesh over the hole to keep insects and vermin from entering the toilet.
Make sure that the mesh is not too fine as this will impede the air flow.
7.2 ADJUSTABLE VENT
If the installed air vent has an adjustable opening, always make
sure to leave the opening at a minimum of 2 inches (50 mm)
when operating the toilet.
OPEN
24|7
10
7.3 VENTILATION TIME
The air inlet vent must always remain open when using the Cinderella toilet.
50 mm
Publicité
Chapitres
Table des Matières
