Start Up And Use; Turning Off - Enders POLO 2.0 Manuel D'installation Et D'utilisation

GB
4.

START UP AND USE

CAUTION: When starting and stopping the device can be slight explosion at the burner.
!
This is not a failure of the Product and is not cause for alarm. Always keep a safe dis-
tance to the burner.
1. Open the regulator valve.
2. Press the regulator button (F) until the small flam symbol appears and at the same time
continuously press the piezo-ignition button (G). After successful ignition, keep the regulator
button pressed for another 10 seconds. This brings the burner up to the necessary operating
temperature.
3. In the rare case that the heater does not ignite after the piezo-ignition button has been pressed
4 or 5 times, repeat the procedure after 2 minutes.
NOTE:
i
It is possible to ignite the device using other primers (matches, fi e sticks) which are igni-
ted through the burner base openings.
5.

TURNING OFF

1. To switch of the device, close the regulator valve.
(G)
(F)
30