Enders POLO 2.0 Manuel D'installation Et D'utilisation page 29

POLO 2.0
CONNECTING THE GAS CANISTER:
CAUTION: The device must not be used without gas pressure regulator (or one of a similar
!
type). Details regarding country-specifi gas pressure regulators can be found on the type
label of the patio heater.
1. Check that all sealants are intact before turning on the device.
2. Connect the pressure regulator with the regulator valve. Please refer to the separate book of
instructions enclosed for the gas pressure regulator.
3. Connect the hose to the gas supply of the pressure regulator using the gripper clamp.
4. Check that all connection points are leak-proof when the regulator valve is open. For this pur-
pose an approved leakage locating spray or foaming agent (e.g. Gas Control Sprayor suds) is
recommended. Apply this to the hose junctions. The sealant properties are ensured if no bub-
bles appear.
CAUTION: Never check the sealant properties using a naked flam as this could ignite any
!
leaking gas!
CAUTION: The gas canister should only be replaced in a well-ventilated room, away from
naked flame (e.g. candles, cigarettes, other devices with naked flames)
29
546023