SEVERIN SM3580 Mode D'emploi page 10

the required length before use.
Frothing-coil storage
When the frothing coil is not in use, it may be
stored on the underside of the lid.
Operation
∙ We recommend using milk with a high
protein content. For best results, the
milk should be taken from the refrigerator
immediately before frothing.
∙ Always ensure that the contact surface
between the base and the milk container
is clean and dry.
Preparing the stirring insert
∙ For frothing milk, fi t the coil to the stirring
insert.
∙ For simply heating milk, the stirring head
is used without the coil.
Fill amounts
∙ For frothing, fi ll the container to a
maximum of 150 ml (lower max mark
∙ For heating, fi ll the container to a
maximum of 250 ml (upper max mark ).
Heating or frothing milk
∙ Unwind the cord to the required length
and connect the appliance to the mains.
∙ Place the container onto the base.
∙ Remove the lid from the milk container.
∙ Fit the stirring insert (with or without the
frothing coil) in the centre of the milk
container, ensuring that the head of the
insert is properly locked in place by the
magnetic holder.
∙ Put the required amount of milk into the
container.
∙ Place the lid on the container.
∙ Press the On/Off switch once if you want
10
to heat up milk.
∙ The indicator light shows red, and the
appliance begins to heat up and stir the
milk.
∙ For cold-frothing, press the On/Off switch
twice.
∙ The indicator light shows blue, and the
appliance begins to stir the milk.
∙ Once the milk is suffi ciently heated or
frothed, the stirring and heating processes
stop automatically, and the indicator light
goes out.
∙ You can now remove the milk container
from the base.
∙ Pour out the milk, or use a suitable spoon
to take off the milk froth.
∙ Detach the power cord from the wall
socket after use.
Remark
Always allow the appliance to cool down
fi rst, before starting a new cycle.
). Hint
To achieve a thicker froth, go through a cold-
frothing cycle fi rst, followed by a hot-frothing
cycle.
Making hot cocoa
The appliance is also suitable for the
preparation of cocoa drinks. Proceed as
described in 'Heating up or frothing milk'
(having fi rst fi tted the stirring insert without
the frothing coil) and turn the appliance on.
Take off the lid after about a minute, put in
the desired amount of cocoa powder and
replace the lid.
To prevent the mechanism from becoming
blocked, only milk-soluble cocoa powder
should be used.