Danby DAC080EB2GDB Guide D'utilisation Et Soins De Propriètaire page 15

Operating Instructions
USING THE REMOTE
CONTROLLER
BUTTONS
NOTE:
To cancel the TIMER setting, push the TIMER button until "0 hours" is
displayed on the LCD window of the air conditioner.
1
12
TIMER OPERATION
To set the Auto-start time.
1) Push the TIMER button when the unit is
operational; only the Auto-stop feature
can be set.
2) Keep pressing the TIMER button. Each
press will increase the selected time by
1
1 hour increments, up to 24 hours.
3) The time can be set in a range of 0 - 24
hours.
4) After the desired time has been selected,
wait for about 10 seconds, until the setting
temperature reappears in the display window
of the air conditioner. This indicates that
the program has been set.
ENERGY SAVER OPERATION
This function is available in Cool, Dry, and Auto
modes (only Auto-Cool and Auto-Fan modes).
The fan will continue to run for 3 minutes after
the compressor has shut off. The fan then cycles
on for 2 minutes at 10 minute intervals, until the
room temperature is above the set temperature.
At this point, the compressor turns back on and
cooling starts.