Dust Extraction; Cover Plate - Makita DJV182 Manuel D'instruction

1
014119
To remove the blade, push the tool opener forward as
far as it will go. This allows the blade to be released.
NOTE:
Occasionally lubricate the roller.
•
Hex wrench storage
1
014109
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.

Cover plate

014127
Use the cover plate when cutting decorative veneers,
plastics, etc. It protects sensitive or delicate surfaces
from damage. Fit it on the back of the tool base.
1. Jig saw blade
1. Base
2. Hex wrench
2
1. Cover plate
1
2. Base
2
Anti-splintering device
1
014121
For splinter-free cuts, the anti-splintering device can be
used. To install the anti-splintering device, move the tool
base all the way forward and fit it from the back of tool
base. When you use the cover plate, install the anti-
splintering device onto the cover plate.
CAUTION:
The anti-splintering device cannot be used when
•
making bevel cuts.

Dust extraction

The dust nozzle (optional accessory) is recommended
to perform clean cutting operations.
2
013878
To attach the dust nozzle on the tool, insert the hook of
dust nozzle into the hole in the base.
1
014122
To secure the dust nozzle, tighten the clamp screw at
the front of the dust nozzle.
The dust nozzle can be installed on either left or right
side of the base.
8
1. Anti-splintering
device
2. Base
2
1. Dust nozzle
2. Base
1
1. Clamp screw