Makita DJV182 Manuel D'instruction page 9

1
014117
Then connect a Makita vacuum cleaner to the dust nozzle.
OPERATION
CAUTION:
Always hold the base flush with the workpiece.
•
Failure to do so may cause blade breakage,
resulting in a serious injury.
NOTE:
If the tool is operated continuously until the battery
•
cartridge has discharged, allow the tool to rest for
15 minutes before proceeding with a fresh battery.
1
014110
Turn the tool on without the blade making any contact
and wait until the blade attains full speed. Then rest the
base flat on the workpiece and gently move the tool
forward along the previously marked cutting line.
When cutting curves, advance the tool very slowly.
Bevel cutting
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before tilting the base.
014111
1. Dust nozzle
2. Hose for vacuum
cleaner
2
1. Cutting line
2. Base
2
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
1
014112
To tilt the base, loosen the bolt on the back of the base
with the hex wrench. Move the base so that the bolt is
positioned in the center of the bevel slot in the base.
1
3
2
014123
Tilt the base until the desired bevel angle is obtained.
The V-notch of the gear housing indicates the bevel
angle by graduations. Then tighten the bolt firmly to
secure the base.
Front flush cuts
1
014113
Loosen the bolt on the back of the base with the hex
wrench and slide the base all the way back. Then
tighten the bolt to secure the base.
Cutouts
Cutouts can be made with either of two methods A or B.
9
1. Base
2 2. Hex wrench
3. Bolt
3
1. Bevel slot
2. Base
3. Bolt
6
4. Graduations
5
5. V-notch
6. Gear housing
4
1. Base
2
2. Hex wrench
3. Bolt
3