Metal Cutting; Dust Extraction - Makita VJ01 Manuel D'instruction

B) Plunge cutting
012325
You need not bore a starting hole or make a lead-in
cut if you carefully do as follows.
(1) Tilt the tool up on the front edge of the base
with the blade point positioned just above the
workpiece surface.
(2) Apply pressure to the tool so that the front
edge of the base will not move when you
switch on the tool and gently lower the back
end of the tool slowly.
(3) As the blade pierces the workpiece, slowly
lower the base of the tool down onto the
workpiece surface.
(4) Complete the cut in the normal manner.
Finishing edges
012326
To trim edges or make dimensional adjustments, run the
blade lightly along the cut edges.

Metal cutting

Always use a suitable coolant (cutting oil) when cutting
metal. Failure to do so will cause significant blade wear.
The underside of the workpiece can be greased instead
of using a coolant.

Dust extraction

1
012327
1. Dust cover
2. Hose
2
Clean cutting operations
connecting this tool to a Makita vacuum cleaner. Insert
the hose of the vacuum cleaner into the hole at the rear
of the tool. Lower the dust cover before operation.
NOTE:
Dust extraction cannot be performed when making
•
bevel cuts.
Rip fence (optional accessory)
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before installing or
removing accessories.
1. Straight cuts
012328
When repeatedly cutting widths of 160 mm or less,
use of the rip fence will assure fast, clean, straight
cuts.
1
2
012329
To install, insert the rip fence into the rectangular
hole on the side of the base with the fence guide
facing down. Slide the rip fence to the desired
cutting width position, then tighten the bolt to
secure it.
8
can be performed
1. Rip fence
(Guide rule)
1
1. Bolt
2. Fence guide
3. Hex wrench
4. Rip fence
(Guide rule)
3
4
by