Safety Notice; Maintenance And Checks - hymer 6573 Instructions De Montage Et D'utilisation

4. Stability
The stability of the tower is such, that when used indoors with 4
stabilisers, no ballast is needed.
Notice: when necessary according to the instructions, stabilisers
and ballast have to be used.

5. Safety notice

- Before use, check if the tower has been erected correctly and
completely and check safety equipment.
- Apply brakes (red pedal in down position).
- Mobile aluminium towers should be moved lengthwise and at normal
walking speed.
- Avoid contact with other objects.
- Move towers with two stabilisers only under calm wind conditions.
- The mobile aluminium tower may only be used when all precautionary
guardrails and toeboards are in place, according to the manufacturers
instructions.
- Trapdoors should be closed, except when in direct use.
- Be aware of horizontal and vertical loads which may lead to tipping
over of the aluminium tower e.g.:
- horizontal loads (working on other structures, push off
effect of heavy equipment, ...)
- extra windloads, like windtunneleffect in open structures,
corners at buildings
- Tools and materials should be passed on from below. Do not
overload platform.
- Only one platform may be loaded at a time.
- Work may only be carried out on one platform at a time.
- More than one person may stand on the platform, provided the ma-
ximum total load is not exceeded.

6. Maintenance and checks

- All parts of the aluminium tower should be handled carefully when
transported to avoid damage.
- Store all parts correctly and safely to avoid damage.
- Protect all parts against weathering.
- Check all moving parts on their functioning and on being clean.
- Check all parts on damages.
- Replace damaged parts.
2016-05 0095537 6573
At windspeeds of 12m/s and more, the stability is not being
guaranteed. Extra windload should be taken in account (tunnelwinds
in open structures, corners at buildings). In these cases the tower
should be dismantled or moved into a safe zone, or secured otherwise.
- Check the functioning of stabilisers (if attached) before using the
aluminium tower.
Stabiliser in supporting
position:
Tighten knob in lower
position.
- Fitting and securing of the stabiliser bar enlargement (if attached).
- Do check national and local legislation before every use.
© Hymer-Leichtmetallbau
The contents of these instructions in any form (e.g. written or
electronically) may under no circumstance being copied,
passed on or published without written permission of Hymer-
Leichtmetallbau.
(Under reserve of errors and technical changes)
Stabiliser when aluminium
tower is moved:
Tighten knob in upper
position.
13