EHEIM proxima 175 Mode D'emploi page 8

GB
A Unpacking / choosing location
Carefully unpack the aquarium and furniture.
The lighting equipment and cover panes are packaged and in the aquarium.
A Choosing location
No sun exposure, not too much daylight. Position away from radiators, close to a mains power
socket and on a level and stable surface.
Attention should be paid to the total load on the floor.
When assembling the furniture, use a spirit level to make sure it is exactly level and ensure
that the stand is stable.
A Feet
If necessary, place furniture feet underneath to ensure a level position.
B Assembly
The device's power cable cannot be replaced. An external power cable or
power supply unit must not be repaired. In case of cable damage, the
device must no longer be used. If an external power cable or power
supply is damaged, they must always be replaced.
Contact your specialised dealer or your EHEIM Service Centre.
There must be a gap of at least 15mm between the lights and the surface
of the water
When cleaning the glass, ensure that the glued joint is not damaged.
Be careful when using cleaning instruments with razorblades.
Do not use cleaning agents containing toxic substances.
For your own safety, we recommend to form a drip loop with the
connection cable to prevent any water running along the cable from
intruding into the socket. When using a multiple socket or an external
power supply unit, position them atop the filter's power connection.
This equipment is not intended for use by persons (including children)
with limited physical, sensory or mental abilities or for persons with no
experience or knowledge unless they are supervised by a person
responsible for safety or unless they have received from such a person
instructions on how to use the equipment.
Children should be supervised to ensure that they do not play with the
equipment.
Do not clean the unit – or parts of it – in the dishwater. Not dishwater
resistant!
Do not dispose of this product as normal household waste. Take it to
your local refuse collection side.
The product complies with the protection requirements of the EC Low
Voltage Directive 2006/95/EG and with 2004/108/EG.