Two Piece-Shaft; Maintenance Schedule - Husqvarna 535LK Manuel D'utilisation

Two piece-shaft

Apply grease to the end of the drive shaft after each 30
hours of operation. There is a risk that the drive shaft
ends (splined coupling) on models with two-piece shafts
will seize if they are not lubricated regularly.
Maintenance
Clean the external surface.
Make sure that the throttle trigger lock and the throttle works correctly from a
safety point of view.
Do a check of the stop switch to make sure that it works correctly.
Make sure that the cutting attachment does not rotate at idle speed.
Clean the air filter. Replace if necessary.
Examine the cutting attachment guard for damages and cracks. Replace the
guard if it has been exposed to impact or is cracked.
Examine the trimmer head for damages and cracks. Replace if damaged.
Make sure that the screws and nuts are tight.
Examine the engine, the fuel tank and the fuel lines for leaks.
Clean the cooling system.
Examine the starter and the starter rope for damages.
Examine the vibration damping elements for damages and cracks.
Clean the outside of the spark plug. Remove it and do a check of the electrode
gap. Adjust the gap to the correct distance (see,
page 17 ) or replace the spark plug. Make sure that the spark plug is fitted with a
suppressor.
Clean the outside of the carburettor and the space around it.
Do a check of the bevel gear to make sure that it is filled three-quarters with with
lubricant. Use special grease to fill if neccessary.
Clean or replace the spark arrestor mesh on the muffler (only applies to mufflers
without a catalytic converter).
Do a check of the fuel filter for contamination and the fuel hose for cracks or oth-
er defects. Replace if neccessary.
18

Maintenance schedule

The following is a list of the maintenance steps that must
be performed on the product. Most of the items are
described in
Note:
The user must only carry out the maintenance
and service work described in this operator's manual.
More extensive work must be carried out by an
authorized service workshop.
To examine the spark plug on
Maintenance on page 15
Daily Weekly
X
X
X
X
X
X
X
X
X
331 - 009 - 30.01.2021
Monthly
X
X
X
X
X
X
X
X