Accessory List - Elem Garden Technic CBE1201 Traduction Des Instructions D'origine

ASSEMBLY

1. ACCESSORY LIST

1) Guard
2) Nut x 1
3) Bolt x 2
4) Locking knob x 1
5） Hexagon spanner
2. ASSEMBLY OF GUARD
The only assembly required for your trimmer is to install guard
1) Remove the cutting head, place the guard on the shaft.
2) Slide the guard over the cutting head along shaft.
3) Fit the guard to the support of the shaft, make sure the guard sits level on the cutting head.
The larger side of the guard should be facing the same direction as the rear handle.
4) Insert the bolt through the hole of support of shaft and the hole of guard, tighten the bolt and
nut with the hexagon spanner.
3. ASSEMBLY OF SHAFT
1) Push angle regulator to raise the locking pin up, connect the two shafts of appliance and
align
the driving pin the hole.
2) Rotate the shaft of the cutting head to the angle with the two holes of the shaft aligned
together.
3) Release the angle regulator and let the locking pin lock the two shafts.
4) Insert the bolt through the hole of shaft and tighten the shaft locking knob.