Installation And Operation; Safety Instructions - Bartscher A150.674 Mode D'emploi

5. Installation and operation

5.1 Safety instructions

WARNING! Electrical hazard!
The device must only be connected to a properly installed single socket with
protective contact.
Never yank cord to disconnect from outlet.
Cable must not touch any hot parts.
• See that the cable does not touch any heat sources or sharp edges. Do not let the
cable dangle over the counter edge.
WARNING! Hot surface!
During operation some elements of the unit very become hot. To avoid burns, do
not touch hot elements!
Do not use the device in case it does not function properly, has been damaged or
•
dropped.
• Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the
device or personal injury, and further, the warranty expires.
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep
•
away the cable from operating range and do not dunk it into water.
• Do not move or tilt the device when in operation.
• In case of thunderstorms and similar, disconnect the device from the mains
immediately! This prevents damage to the device by lightning.
CAUTION! Risk of injury!
Never remove the casing and never modify the degvice yourself! Modifying the
device may lead to sever damage to persons and objects!
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with that
of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!
- 22 -