Coffee Strength; Making Coffee; Status Light; Using The Timer - Russell Hobbs 25270-56 Mode D'emploi

BEFORE USING FOR THE FIRST TIME
Fill the reservoir to the max mark, and run the appliance without coffee.
FILLING
1. Remove the carafe from the hotplate.
2. Open the lid.
3. Fill the reservoir with the exact amount of water required. Note that the brewing process will use all
of the water that you put in the reservoir.
4. Make sure that the filter holder is pressed down all the way into position. It will click when correctly
installed.
5. Put a #4 paper filter into the filter holder.
6. The reservoir is calibrated to give 12 large cups (at 125ml per cup) and 18 small cups (at 83ml per cup).
For each large cup, add 6g of ground filter coffee and for each small cup add 4g.
7. Close the lid.
8. Replace the carafe on the hotplate.
SET THE CLOCK
It isn't neccessary to set the clock to use your coffee maker but you will need to set it if you want to use
the timer functions.
1. Put the plug into the power socket.
Use the hr and min buttons to set the correct time in 24 hour format.
2.
• The clock will retain its settings until the coffee maker is unplugged.

COFFEE STRENGTH

Pressing the f button will make the brewed coffee slightly stronger. You can also use it if you are only
brewing a partial carafe of coffee (i.e. not completely filling the reservoir). Your coffee maker will then alter
the brewing process so your coffee will have about the same strength as it would if you had made a full
carafe.

MAKING COFFEE

Note: If you want to use the coffee strength feature press the f button before pressing the W button.
The f button will light up.
1. Press the W button – the 1 icon will appear on the display. The W button will light up.
2. Shortly afterwards, coffee will start to drip into the carafe.
3. If you want to stop the coffee maker while it's brewing, press the W button.
4. Once brewed, the hotplate will keep the carafe warm for up to 40 minutes.

STATUS LIGHT

The status light will operate as follows:
Brewing
Keep warm
Last 10 minutes of keep warm

USING THE TIMER

Note: Make sure the clock is set to the correct time. Use the hr and min buttons.
1. Set the timer to the time you want to start brewing.
Press the T button.
a)
b) Use the hr and min buttons to set the time you want brewing to start.
Flashes slowly
Stays lit
Flashes quickly
4