Flex FX1471 Manuel De L'utilisateur page 14

WARNING
product damage due to a short circuit, never
immerse your tool, battery pack or charger
in fluid or allow a fluid to flow inside them.
Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and
bleach or bleach-containing products, etc. can
cause a short circuit.
WARNING
this product until the parts are replaced. Use
of this product with damaged or missing parts
could result in serious personal injury.
This impact wrench must be used only with the battery packs and chargers listed below:
2.5Ah 5Ah
FLEX FX0111 FLEX FX0121
NOTICE: Please refer to the battery pack and charger manuals for detailed operating
information.
TIGHTEN AND LOOSEN NUTS AND BOLTS
To tighten nuts and bolts
Use the hex socket that matches the nut or bolt.
Select a proper working mode depending on the
type or size of the bolt and nut. Before starting
your job, always perform a test operation to
determine the proper fastening time for your bolt
or nut.
a. Set the direction-of-rotation selector to
forward setting.
b. Hold the tool firmly and place the socket over
the bolt or nut. Ensure that full length of the
bolt head or nut is fully engaged into socket.
c. Depress the variable-speed trigger switch
to turn the impact wrench on. Start slowly,
increasing the speed as the nut or bolt runs
downs. Set the nut or bolt snugly by slowing
the tool to a stop.
WARNING
a tendency to torque or twist in your hands.
d. Fasten the bolt or nut to the proper torque.
OPERATING INSTRUCTIONS
To reduce the risk of fire,
personal injury, and
If any parts are damaged
or missing, do not operate
Battery Pack
8Ah
FLEX FX0221
(FIG. 9)
If this procedure is not
followed, the tool will have
WARNING
accessories not recommended for use with
this tool. Any such alteration or modification is
misuse and could result in a hazardous
condition leading to possible serious injury.
WARNING
serious personal injury, always remove the
battery pack from the tool when assembling
parts.
12Ah
FLEX FX0231
Fig. 9
e. After fastening, always check the torque with
a torque wrench. If the fasteners are too tight,
reduce the impacting time. If they are not tight
enough, increase the impacting time.
NOTICE: Hold the tool straight along the axis
of the bolt or nut.
NOTICE: Excessive fastening torque may
damage the bolt/nut or socket.
-14-
Do not attempt to modify
this tool or create
To prevent accidental
starting that could cause
Charger
FLEX FX0411 FLEX FX0421