Variable-Speed Trigger Switch - Flex FX1471 Manuel De L'utilisateur

DIRECTION-OF-ROTATION (FORWARD/
CENTER-LOCK/REVERSE) SELECTOR
After tool use, lock the
WARNING
selector in the "OFF" position (center-lock)
to help prevent accidental starts and
possible injury.
Your tool is equipped with a direction-of-rotation
selector, located above the variable-speed
trigger switch. This selector is used to change
the direction of rotation of the bit and to lock the
variable-speed trigger in the "OFF" (center-lock)
position.
a. Position the direction-of-rotation selector to
the far left of the tool to tighten bolts/nuts
(Fig. 5).
b. Position the direction-of-rotation selector to
the far right of the tool to loosen bolts/nuts
(Fig. 5).
c. Position the switch in the "OFF"
(center-lock) position to help reduce the
possibility of accidental starting when not in
use.
NOTICE: To prevent gear damage, always allow
the impact wrench to come to a complete stop
before changing the direction of rotation.

VARIABLE-SPEED TRIGGER SWITCH

Your tool is equipped with a variable-speed
trigger switch. The tool can be turned ON or
OFF by depressing or releasing the variable-
speed trigger switch.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
ADJUSTMENTS
direction-of-rotation
(FIG. 6)
Fig. 5
NOTICE: The impact wrench will not run unless
the direction-of-rotation selector is engaged fully
to the left or to the right.
WARNING
Therefore, the direction-of-rotation (forward/
center-lock/reverse) selector should always
be locked in the center position when the
tool is not in use or when carrying it at your
side.
Fig. 6
Variable-speed
Trigger Switch
-11-
Battery tools are always in
operating condition.